Already steam turbines fire up a steam plasma in the turbine. We3 can use this to increase the power output of the station.
We have two electrodes at the base and real of the turbine. We pass a small current through the plasma – 20 V 0.08 amp-s.
The power output of the station goes up by 20%, From 100 to 120 MW. For the same fuel burn.
We replace the Ni turbine blades with ceramic blades – coated in TiO. This will double the power output of the modern power station. But this is all high science – as is replacing metal oxide fission rods, with steam plasma tubes.
These convert regular water into 8 times the power of U fission tubes. And we top up with very little regular water.
But people want an idea they can use.
If you have a 50x1cm steam plasma tube in your garage, you can drive a 24 kW turbine bought off the internet.
And produce the power for 8 houses from regular water. Generating an annual income of 3.6 million UK pounds, with no CO2 or radioactive waste.
They tube does Molecular Nuclear Fusion
1 H2O+TU ->E2+L+X-ray
So best to sit it in a water tank, to block the X-rays. Do thermally insulate it from the water. But this is still high science.
Take you car along to a metal plating firm. And get a Ti plate on your car cylinder and cylinder head. Or both surfaces of your Wankle engine.
Turn your car ignition mode down to economy mode – or tweak the carburettor,, until you get a normal tick over rate.
Your car will now produce the same power for half the fuel. For life. Ti plate your central heating boiler plate, to helve your coal, gas or oil burn.